Neotherm * Liquid Insulation 10L
High quality insulation material for roofs and exterior walls. Certified products with low thermal conductivity and high reflectivity. Contains special materials with low thermal conductivity, which provides energy savings during the summer and winter period to 30%.
High quality insulation material for roofs and exterior walls. Certified products with low thermal conductivity and high reflectivity. Contains special materials with low thermal conductivity, which provides energy savings during the summer and winter.
Reduces energy consumption by approximately 30%
It is applied and dries to a smooth film that covers capillary cracks.
There is extremely low thermal conductivity (5 times smaller than a coefficient of thermal conductivity (λ) relative to that of the concrete), which prevents the transmission of ambient temperature within the building.
The resultant coating is equivalent to the isolation of the tree 5 cm thick.
High strength even at low temperatures.
Prevents condensation of vapor inside the building and development of molds.
During the summer period, in combination with Neoroof / Silatex ®Reflect, significantly reduces the temperature
within the building. At the same time, at low temperature to prevent freezing of the surrounding walls providing a barrier to cold, which is transmitted inside the building by convection.
Contains a high percentage of micro-bubbles. Even if it is applied in the ordinary paint, it has the ability, in the summer, to radiate heat from the surface to the atmosphere.
Appearance: viscous liquid
Density: from 0.85 to 0.95 g / cm3, 0,98 ± 0,03 kg / L
Consumption: 0.5 - 0.7 l / m2
Drying time: 2-3 hours at 25 ° C
Drying for re-plastering: 24 hours
Dilution with water: up to 5%
Thermal conductivity (λ): 0,136 W / Mk (EN 12664: 2004)
Reflection (%) -Vidimo / 400nm-700nm: 91 (ASTM E903-96)
Total reflection (SR%): 88 ASTM G159-98)
Ideks of solar reflection (SRI): 111
Total radiation: 0,86 (ASTM E408-71)
- CRES - Centre for Renewable Energy and Energy Research Laboratory at the University of Athens
Surface Preparation: Surfaces must be dry, clean of dust, dirt, grease and loose materials. Before applying Neotherm® to stabilize the surface and traction is applied 1 layer Revinex diluted with water (Revinex: Water 1: 3)
Application: Neotherm® applied after a stirring, at least two layers. Apply with a brush or roller. The first layer was diluted with water (5%). The second is administered after 24 hours, without dilution. To obtain good thermal insulation should follow the instructions on cost. After Neotherm ®, to make two layer Neoroof ® (roof) or Silatex ®Reflect (for walls).
· Neotherm® should not be applied in wet weather or if rain is forecast in the next 48 hours
· Relative humidity at the surface <6% relative atmospheric humidity <70
· Fully cured film achieves 14 days after application
Cleaning of tools:
With water immediately after use
Remove stains from material:
While still not dry - with water. If hardened - by mechanical means
Color: Light blue
Packaging: Buckets of: 3 l, 10 l
2 years in original sealed container, protected from frost and sunlight.